One call covers it. You describe what you are seeing, we ask a few questions to scope the job, and you get a price before anything is scheduled. That is how every visit starts, whether the problem is a shower valve that stopped working, a water heater that quit overnight, or a drain that has been running slow for weeks. We take calls every day from 9 AM to 10 PM, and the person who answers knows the trade well enough to have a real conversation about what the job involves.
Fox Point is a town of well-established homes, most of them sitting on full basements, and the plumbing in those houses reflects that age. Galvanized lines, older fixture valves, and sewer runs that have never been touched are common. We handle all of it, from a straightforward fixture swap to a full repipe, and we work with homeowners and property managers across the town and the surrounding area.
Call (414) 451-9789 to get a quote.
The plumbing around here follows a few common setups, and the calls we get reflect that. Older housing stock means aging pipe materials, slower drains from decades of buildup, and water heaters that are well past their expected service life. Below is a closer look at the specific work we handle most.
A shower that runs too hot, too cold, or will not hold a temperature is usually a valve problem rather than a water heater problem. Cartridges wear out, pressure-balancing valves stick, and older mixer setups lose their range of adjustment over time. We pull the valve, assess whether the cartridge is the issue or the valve body itself needs to go, and confirm the fix before we leave.
A disposal that hums but will not spin has a jammed impeller. One that trips the reset every few days is drawing too much current, which usually means the motor is going. When repair no longer makes sense, we swap in a replacement that fits the existing drain configuration and confirm the connection is tight on both the drain side and the supply side.
A toilet that rocks slightly is not just a nuisance. Movement at the base works against the wax seal, and a failed seal means water is leaking into the subfloor rather than into the drain. We reseat the toilet, replace the wax ring, and check the flange condition before setting the new seal. If the flange itself is cracked or corroded, that gets addressed before the toilet goes back down.
Galvanized steel pipe corrodes from the inside out. The narrowing is gradual, which is why low pressure at every fixture in the house is often the first sign rather than a visible leak. Polybutylene pipe has a different failure mode, cracking from water chemistry and pressure fluctuation over time. When either material is the underlying issue, patching individual leaks is a short-term answer. We walk through what a full replacement involves and what it would take to move the whole house to copper or PEX.
Most homes in this area sit on full basements rather than slabs, but slab construction does appear in certain properties. When a supply line running under a concrete floor develops a leak, the signs are a warm spot on the floor, a water bill that has climbed without explanation, or the sound of running water when nothing is on. We use pressure testing to confirm the leak and locate it before any concrete is opened up.
A tankless unit heats water on demand rather than keeping a tank at temperature around the clock. Installation involves more than swapping out the old unit. The gas line or electrical supply may need to be upsized, the venting runs differently, and the cold-water inlet and hot-water outlet connections have to be sized for the flow rate the unit requires. We confirm what the installation involves on the call before anything is ordered.
Don't let a small leak turn into a flooded floor, especially when a previous repair has already been done and the problem has returned. We take over mid-project work and second-opinion calls without any friction. If another plumber patched a line and the leak came back, we start from the beginning rather than assuming the earlier diagnosis was right.
That means pressure-testing the affected section, checking the surrounding pipe for related wear, and giving you a clear picture of what actually needs to happen. Sometimes the original repair was sound and something adjacent failed. Sometimes the patch was always temporary. Either way, you get a straight answer about what the job actually requires before we start.
We also handle work that was started and not finished. Rough-in left incomplete, a fixture installed without the supply line connected, a water heater swapped without the pressure relief valve being replaced. We come in, assess what is there, and bring the job to a proper finish.
It does, and in specific ways. Homes built in the mid-twentieth century often still carry their original galvanized supply lines. Those lines have a finite life, and a house that has had the same pipes since it was built is likely running on borrowed time in at least one section of the system. The pressure drop that shows up at a showerhead or a kitchen faucet is usually the first sign, not the leak.
Drain lines in older homes are frequently cast iron. Cast iron holds up well for a long time, but it does corrode from the inside, and root intrusion through older joints is common. We camera the line when the symptoms suggest the problem is in the pipe rather than just the drain opening.
Fixture connections are another place where age shows up. Compression fittings that were installed decades ago, supply stops that have not been turned in years, and valves that no longer fully close are all things we check as part of any visit where the surrounding plumbing is old. Knowing where the main shutoff is helps in any plumbing emergency, and on older properties we confirm it is actually working before we leave.
Some plumbing work requires a permit and an inspection before the job is closed out. What falls into that category depends on the municipality, and the rules in one town are not always the same as those in the next. We tell you if a permit is needed. We explain repair or replace. You make the choice.
Generally speaking, work that involves moving or adding to the drain, waste, and vent system, replacing a water heater, or making changes to the supply line past the main shutoff is more likely to require a permit than a fixture swap or a repair to an existing line. We handle the permit process when it applies and confirm what the inspection covers before the work is scheduled.
The permit affects timing. A job that needs an inspection cannot be fully closed out until the inspector signs off. We factor that into how the work is sequenced so the property is functional while the inspection is pending.
The price follows the job, and the job depends on what we find. When you call, we scope the work on the phone based on what you describe. For most repair and installation calls, that conversation is enough to give you a real number before anything is scheduled. For larger work, like a full repipe or a sewer line replacement, the scope gets confirmed in person before the final price is set.
What moves a quote is what the job turns out to involve once the work is underway. A supply line repair that uncovers corroded pipe on both sides of the break is a different job than the call described. We explain what changed and what it means for the cost before the work continues. The price is confirmed before we start, and any change to it gets discussed before it happens.
Call (414) 451-9789 and we will give you a rate on the call.
Plumbing problems don't wait, and neither do we. For urgent calls, including burst pipes, sewer backups, and water heaters that have stopped working entirely, we take short-notice work and treat those calls as the priority they are. We are available every day from 9 AM to 10 PM.
For scheduled repairs and installations, the booking process is straightforward. You call, we scope the job, confirm the price, and set a time. If you are managing a rental property or a building with tenants, we work around access requirements and occupancy schedules. A tenant who cannot be without hot water for two days changes how the job gets sequenced, and we account for that on the call.
We protect your home. We fix your pipes. We earn the call. Details on each of these are on our plumbing service list.
We serve Fox Point and the surrounding communities throughout Milwaukee County. In addition to Fox Point, we take calls from Bayside, River Hills, Glendale, Whitefish Bay, and Brown Deer.
If you are in the wider county area and unsure whether we cover your address, call (414) 451-9789 and we will confirm.
The work is the same across all of them: repairs, installations, drain cleaning, water heater service, sewer lines, and emergency plumbing. A local plumber for homeowners means the call gets answered by someone who can scope the job and give you a number before anything is booked. Code-compliant plumbing on every job, and fixtures and lines left working before we go.
A toilet that runs continuously can waste a significant volume of water every day, which adds up on a water bill over weeks and months. The exact amount depends on the severity of the run, but even a slow internal leak through a worn flapper adds measurable cost. It is a repair worth making promptly.
Permit requirements vary by municipality, and we confirm what applies at your address before the job is scheduled. Water heater replacements and work involving the drain, waste, and vent system are the categories most likely to require an inspection. We handle that process when it applies and sequence the work so the property stays functional while the inspection is pending.
Yes. Before we leave, we walk through what was done, confirm that fixtures and lines are working, and explain anything the property owner or manager should know going forward. Fixtures and lines left working before we go is the standard we hold to.
A gurgling sound after water drains is usually a venting problem. When a drain vent is blocked or undersized, air gets pulled through the trap water instead of through the vent stack, and the gurgling is that air moving through the trap. It is worth a call because a venting problem can eventually pull the trap dry and let sewer gas into the house.
Homes in this town tend to carry original galvanized supply lines, cast iron drain runs, and fixture valves that have not been serviced in decades. The most common calls are low pressure at multiple fixtures, slow drains that do not respond to basic clearing, and water heaters that have run past their useful life. When the same problem keeps coming back, the pipe material is usually the reason rather than the individual fitting.
The work on the supply side inside the house is the same. If the property has a well pressure system, that affects how we approach pressure testing and shutoff, and we factor that in when scoping the job. Call and describe the setup and we will confirm what the visit covers.
Get the water off first by closing the nearest shutoff valve, then remove standing water as quickly as you can to limit damage to flooring and subfloor. Move anything that can absorb water out of the area.
Then call (414) 451-9789 and we will get the repair on the schedule. The faster the water is off, the less damage it causes.
Reach out to Wauwatosa Plumbing Company at (414) 451-9789 any day between 9 AM and 10 PM.
Whether it is a repair you have been putting off or something that came up this morning, we scope the job on the call and confirm the price before anything is scheduled.
Fast turnaround. Costs explained before we start. Dry results.
We take short-notice calls and get to work as soon as the schedule allows.
Just as close, we take plumbing work in: Bayside, Thiensville, West Milwaukee.
See our full town list.
We handle the full range of plumbing work for homes and commercial properties across Fox Point and the surrounding area. Whether you are dealing with a slow drain, a failing water heater, or a pipe that froze overnight, the table below covers what each service includes and what to expect when you call. Pricing is explained before anything is scheduled, and every job is held to code from start to finish.
| Service | What's Included | When to Call | Helpful to Know |
|---|---|---|---|
| Water Heater Repair & Replacement | Tank and tankless unitsSediment flush and element repairFull unit replacement with sizingGas and water line connections | No hot water, inconsistent temperature, or a tank past its useful life | Replacement units are sized to the household's actual demand before anything is ordered, so you are not paying for capacity you do not need. |
| Pipe Insulation & Winterization | Exposed supply line insulationRim joist and exterior wall runsSeasonal shutoff and drain-down checkOutdoor supply winterization | Older homes with supply lines running through unheated spaces before winter sets in | Confirming that seasonal shutoff valves drain correctly is straightforward work that prevents a much larger repair when temperatures drop hard. |
| Drain Cleaning & Clog Removal | Cable and hydro-jet clearingKitchen, bath, and main line drainsRoot intrusion and buildup removalCamera scoping when needed | Recurring slow drains or full backups in any fixture | Hydro jetting clears the pipe wall, not just the center of the line, which helps prevent the same clog from returning. |
Call (414) 451-9789 to get a price on any of the services above, every day from 9 AM to 10 PM.
(414) 451-9789